To restore the default MAC address, delete the address in the Value field or click Use Default, and then click OK.Įnables the logging of the following link state changes to the system event log.Do not use a multicast address (least significant bit of the high megabyte = 1). For example, in the address 0Y123456789A, Y cannot be an odd number.To enter a new network address, type a 12-digit hexadecimal number in the Value box. The virtual address doesn't change the burned-in (physical) address on the adapter. Make sure no other systems on the network use this address. The Locally Administered Address replaces the MAC address for this network adapter. Noteįor adapters to benefit from this feature, link partners must support flow control frames. You can configure Large Send Offload separately for IPv4 and IPv6. The adapter also uses fewer CPU resources.
If large packets make up the majority of traffic and more latency can be tolerated, Jumbo frames can reduce CPU utilization and improve wire efficiency. Changing this setting can cause a momentary loss of connectivity.Įnables or disables Jumbo frame capability. The issue can also occur in a Forced Slave to Forced Slave mode. If forced to master mode, the device can either disconnect or downshift to a 100-Mbps link. Some multi-port devices can be forced to master mode. The other device is designated as the slave.Ĭhanging the setting can improve link quality with certain link partners. For the latest settings information, go to the Advanced tab in Intel PROSET for Windows Device Manager.ĭecides whether the adapter or link partner is designated as the master. Most advanced configuration settings and definitions are described in the table below. If a configuration setting is not displayed, it's not available for your device or for your Windows* version. Intel® PROSet for Windows Device Manager includes an Advanced tab with Settings options and definitions: Intel® Advanced Network Services (Intel® ANS) isn't supported on In-box drivers.
Intel® PROSet for Windows* Device Manager is a selectable component when you install generic driver and software packages from the Download Center. For additional information on Microsoft Hyper-V virtual NICs on teams and VLANs, refer to the Microsoft* Windows* Driver and Software Installation and Configuration section in the Adapter User Guide for Intel® Ethernet Adapters.